| Material: |
SiC with steel inner tube |
| Application: |
Aluminium, Brass |
| Max. Temperature: |
up to 1000°C |
| Connection: |
standard ½" / 16 mm BSP outside thread
(2..-series, e.g. CERT-248)
also available with ¾" / 21 mm BSP outside thread
(3..-series, e.g. CERT-348) |
| Type: |
CERT-2(+length in inch)
CERT-3(+length in inch) |
|
|
 |
|
Various standard types : |
RÉFÉRENCE |
LONGUEUR (inch) |
LONGUEUR (mm) |
| CERT-212 / -312 |
12" |
305 mm |
| CERT-218 / -318 |
1" |
460 mm |
| CERT-220 / -320 |
20" |
508 mm |
| CERT-222 / -322 |
22" |
559 mm |
| CERT-224 / -324 |
24" |
610 mm |
| CERT-230 / -330 |
30" |
760 mm |
| CERT-236 / -336 |
36" |
915 mm |
| CERT-242 / -342 |
42" |
1065 mm |
| CERT-248 / -348 |
48" |
1220 mm |
| CERT-254 / -354 |
54" |
1370 mm |
| |
|
|
| CERT-M70 |
|
700 mm |
| CERT-M80 |
|
800 mm |
| CERT-M1000 |
|
1000 mm |
|
| Safety and Best Practice SiC Tubes |
Thermal Shock Characteristics: The high Graphite and Silicon Carbide content (circa 90 %) give the thermocouple protection tubes very high thermal shock resistance which allows repeated immersion into molten aluminium without risk of cracking.
Additional coating of the tubes is NOT necessary.
Safety and Best Practise: TPTs from any source should never be immersed in molten aluminium or other metals unless they have been previously dried at above 100º C to remove any water that may have been accidentally spilled on them. This is also applicable to any other fluids such as oil, suspending liquids for wash coatings etc. In the latter case the tubes must be heated to a temperature sufficient to remove them. Failure to carry out the safe practices detailed above risk causing cracking of tubes in an explosive manner.
It is considered best practice to keep the thermocouples in a warm and dry storage area. |
|
| Physical datasheet nitrite bonded SiC (pdf) |
